Due to some unexpected situations in the use of Zhongke Jufeng self feeding mixer, if this happens, how to clean the remaining materials in the tank?

　　1. 关掉控制室的电源开关，并挂上“请勿关闭”的警告牌。

　　1. Turn off the power switch in the control room and hang the warning sign "do not turn off".

　　2. 通知装载机发生碰撞，并将装载机斗与主机出料口对准，收料。

　　2. Inform the loader of collision, align the loader bucket with the discharge port of the host machine and receive the materials.

　　3.打开仓库大门，工人穿戴防护装备进入主机，用铲子、风炮等工具清理未完成的混凝土。

　　3. Open the gate of the warehouse, workers wear protective equipment to enter the main machine, and use shovels, air guns and other tools to clean the unfinished concrete.

　　4. 打开卸料门，取出可拆下的未完成的混合混凝土。

　　4. Open the discharge door and take out the removable unfinished mixed concrete.

　　5. 罐内混凝土清理干净后，工作人员检查主机叶片是否损坏，直至工作人员确认主机底板及叶片状态良好。工作人员离开主机后，关闭主机筒仓门。

　　5. After the concrete in the tank is cleaned, the staff shall check whether the blades of the main engine are damaged until the staff confirms that the base plate and blades of the main engine are in good condition. After the staff leaves the main engine, close the main engine silo door.

　　6. 在车辆供电或正常运行的情况下，工作人员应观察斜带、平带的砂砾情况，配合控制室操作人员通过装载机将砂砾清除。

　　6. Under the condition of vehicle power supply or normal operation, the staff shall observe the gravel condition of inclined belt and flat belt, and cooperate with the control room operator to remove the gravel through the loader.

　　7. 斜带、平带的废料、砂砾清理干净后，进行混凝土的正常生产。

　　7. The normal production of concrete shall be carried out after the wastes and gravel of inclined and flat belts are cleaned.

　　如果在使用全自动自上料搅拌车的过程中出现问题，无法操作时应及时将搅拌机内的混凝土取出。如果混凝土在罐内凝结，会对车辆造成腐蚀。

　　If there is a problem in the use of kejufeng self feeding mixer, the concrete in the mixer shall be taken out in time when it cannot be operated. If the concrete sets in the tank, it will cause corrosion to the vehicle.