How to maintain the mixer at high temperature?

　　1. 防止机体过热:由于环境温度高，发动机容易过热。要加强对发动机冷却系统的检查和维护。这包括检查水箱、恒温器、水泵、风扇等，并注意及时安装。注意冷却水。当水温超过100℃时，在阴凉处停车降温，让发动机空转，打开引擎盖帮助散热。

　　1. Prevent the engine from overheating: due to the high ambient temperature, the engine is easy to overheat. Strengthen the inspection and maintenance of the engine cooling system. This includes checking the water tank, thermostat, water pump, fan, etc., and paying attention to timely installation. Pay attention to the cooling water. When the water temperature exceeds 100 ℃, stop in the shade to cool down, let the engine idle, open the engine cover to help cool down.

　　2、防止发动机爆燃:夏季温度较高，有时超过35℃，而在这样一个季节，对于一些老化的汽车零部件，自然爆燃的概率要高得多。所以做好准备。

　　2. Prevent engine deflagration: the temperature is higher in summer, sometimes over 35 ℃. In such a season, for some aging auto parts, the probability of natural deflagration is much higher. So be prepared.

　　3、防止车漆损坏:车漆经过强烈的阳光照射后，会老化、起皱，而一般的美容蜡会起到一定的防晒作用，但由于任何车蜡含有铋成分，长时间的紫外线照射会使油漆生锈留下小黑点。汽车蜡本身并不能提高硬度或抗紫外线能力，但它在高温下很快就会消失。停车时，注意把车停在阴凉处。

　　3. Prevent paint damage: paint will age and wrinkle after strong sunlight, while general beauty wax will play a certain role in sun protection. However, due to bismuth content in any car wax, long-term UV irradiation will make paint rust and leave small black spots. Car wax itself does not improve hardness or UV resistance, but it will soon disappear at high temperature. When parking, park in the shade.

　　4、防止汽车轮胎爆胎:当温度过高时，更容易爆胎，当温度过高时，轮胎容易变形，抗拉强度降低。至于轮胎本身，压力不达标，轮胎老化，性能变差，或者在行驶过程中轮胎被轧制成硬质金属或其他硬质材料，会导致汽车爆裂。

　　4. Prevent tire blowout: when the temperature is too high, it is easier to blow out. When the temperature is too high, the tire is easy to deform and the tensile strength is reduced. As for the tire itself, if the pressure is not up to standard, the tire is aging, the performance becomes poor, or the tire is rolled into hard metal or other hard materials during driving, it will cause the car to burst.

　　由于给料机高温维护是这样的，希望对您有所帮助：http://www.jufengjiaobanji.com/

　　As the high temperature maintenance of feeder is like this, I hope it can help you.