The self loading mixing conveyor is a special heavy truck. When mixing fuel tanks, the load capacity is large and the road conditions become complex. Due to the increase of inertial centrifugal force, high requirements are put forward for the braking system of self feeding mixing conveyor system. The braking system is very important for the mixer system, but the braking distance of the lift car and the thermal degradation of the brake should be considered first when determining the * * of the mixer. If there is a problem with the braking system of the truck, the driver and passengers are also at risk. Therefore, be careful when applying or applying the brake.

1.制动时发出异常声音

1. Abnormal sound during braking

踩刹车时，刹车系统会引起强烈的金属摩擦。原因可能是刹车片上的异物或刹车盘生锈。

When stepping on the brake, the brake system will cause strong metal friction. The reason may be foreign matters on the brake pad or rust on the brake disc.

2.制动踏板的行程变长

2. The travel of the brake pedal becomes longer

刹车变软时，您会看到笔直的白点。较长的制动冲程主要是由于空气进入制动系统，缺少制动油，可能的泄漏和制动衬块的严重磨损。

When the brakes soften, you will see straight white spots. The longer braking stroke is mainly due to air entering the braking system, lack of brake oil, possible leakage and serious wear of brake pads.

3.制动偏差

3. Braking deviation

制动器打滑不太常见，主要反映了在施加制动器时方向盘向一侧弯曲的事实。造成这种现象的原因可能是制动衬块偏心磨损和制动分泵出现问题。

Brake slip is less common and mainly reflects the fact that the steering wheel bends to one side when the brake is applied. This phenomenon may be caused by eccentric wear of brake pads and problems of brake wheel cylinder.

4.刹车越来越难

4. Braking is becoming more and more difficult

许多卡都有增加制动的问题。加强制动器的主要原因是真空助力器故障。刹车不辅助，经常使用刹车。

Many cards have the problem of increasing braking. The main reason for strengthening the brake is the failure of the vacuum booster. The brake is not assisted, and the brake is often used.

5.刹车回弹

5. Brake rebound

许多卡伙伴都遇到过这种情况，但是在制动时，会出现一种现象，其中上肢从制动踏板上弹起，主要是由于制动盘表面不平整。垫片和钢环变形。

Many card partners have encountered this situation, but when braking, there will be a phenomenon in which the upper limb bounces from the brake pedal, mainly due to the uneven surface of the brake disc. The gasket and steel ring are deformed.