Hello everyone, I'm a small editor of the automatic feeding mixer. Recently, the small editor has learned some latest industry related knowledge, and I'm here to share with you today.
如果不能在混凝土预凝之前将车辆修复,应立即采取应急措施:
If the vehicle cannot be repaired before the concrete pre setting, emergency measures shall be taken immediately:
1、自动上料混凝土搅拌车的马达和减速机无故障情况下,连接“应急油管”将混凝土卸出,预防凝灌事故发生。
1. When the motor and reducer of the automatic loading mixer have no fault, connect the "emergency oil pipe" to unload the concrete, so as to prevent the occurrence of concreting accident.
2、自动上料混凝土搅拌车的马达或减速机发生故障且确定无法在混凝土预凝前使罐体转动,请快速打开人孔盖,如人孔盖不在罐体下方则需要在罐体前锥底部开孔(Φ=1250px,避开原有焊道),与此同时必须持续向进料口灌入大量清水,冲刷罐内混凝土,直罐体下方无混凝土流出,罐内少量残余混凝土需人工进行清理,清理完毕后进行清洗,将割下部分重新焊接到罐体上(安装人孔盖),并打磨喷漆处理。
2. If the motor or reducer of the automatic feeding mixer fails and it is determined that the tank can not rotate before the concrete is pre set, please quickly open the manhole cover. If the manhole cover is not below the tank, it is necessary to open the hole at the bottom of the front cone of the tank (Φ = 1250px, avoiding the original weld pass). At the same time, a large amount of clear water must be continuously poured into the feed inlet to wash the concrete in the tank until there is no concrete under the tank When the concrete flows out, a small amount of residual concrete in the tank needs to be cleaned manually. After cleaning, clean it, weld the cut part to the tank body (install the manhole cover), and polish and spray paint.
以上就是自动上料混凝土搅拌车的小编为大家带来的知识,希望能对您起到帮助。
The above is the knowledge brought to you by the small part of the automatic feeding mixer. I hope it can help you.